Average Outgoing Quality Limit Notes: Definitions & Explanations PDF | Download eBooks
Study Average Outgoing Quality Limit lecture notes PDF with total quality management definitions and explanation to study What is Average Outgoing Quality Limit?. Study average outgoing quality limit explanation with TQM terms to review total quality management course for online MBA programs.
Average Outgoing Quality Limit Definition:
Maximum ordinate on the AOQ curve that represents the worst possible average quality that would result from the rectifying inspection program is called the average outgoing quality limit (AOQL).
Introduction to Statistical Quality Control by Douglas C. Montgomery
Average Outgoing Quality Limit Notes:
Average outgoing quality (AOQ) is the quality of a batch of products after applying rectifying inspection. It is the average quality which is obtained after all the defective products are expected to be replaced with good products. It is evident from the average outgoing quality curve that when incoming material is good, outgoing quality will be good. In addition, another extreme of the AOQ curve is that when incoming material is bad, a lot of rejection takes place during inspection making the outgoing products good. In between these two extremes, there is a point on AOQ curve which shows the worst average outgoing quality for a batch of products. This point is called average outgoing quality limit (AOQL). Average outgoing quality limit gives the value of maximum percent defective in a batch or products that are to be shipped to the customers.
Keep Learning with TQM Notes
What is Supplier Audit?
Supplier audit is a type of performance audit that focuses on the performance of a supplier/suppliers. The modern trend of ...
What is Reactive Customer Driven Quality?
Although it is important to understand customers' expectations and demands, but sometimes the feedback from customers is interpreted incorrectly. Due ...
What is External Validation?
In process improvement, assessment of the procedures etc. is important. This can be done by two ways, internal validation and ...
What is Qualitative Audit?
\Usually, the factors that can be quantified are audited in an organization. These include financial audits, performance audits etc. However, ...
What is Just-in Time (JIT)?
Just-in time is a manufacturing system where the main focus is on waste reduction. It is also called Toyota manufacturing ...
What is Available Time?
An important type of data or information that can be collected through value stream mapping is available time. As the ...
