Rational Subgroup Notes: Definitions & Explanations PDF | Download eBooks
Study Rational Subgroup lecture notes PDF with total quality management definitions and explanation to study “What is Rational Subgroup?”. Study rational subgroup explanation with TQM terms to review total quality management course for online MBA programs.
Rational Subgroup Definitions:
A rational subgroup is a group of data that is logically homogeneous.
Managing Quality: Integrating the Supply Chain by S. Thomas Foster
Rational Subgroups are the subgroups or samples where the chance for differences between subgroups is maximum,while the chance for differences within a subgroup is minimum.
Introduction to Statistical Quality Control by Douglas C. Montgomery
Rational Subgroup Notes:
Rational subgroups allow to collect and arrange data into groups that are under similar conditions. In this case, variations are measured between the subgroups instead of the individual data points. In quality control, rational subgroups aid in identifying variation in control charts that is short term which in turn helps in predicting long term variations that can cause later. If the variation between the two rational subgroups is not considered, it will result in a special cause variation within the process. The observations of rational subgroups are time-ordered. Moreover, the observations does not depend on one another or it can be said that one observation is not a result of another.
Keep Learning with TQM Notes
What is Scrap Cost?
Quality control is necessary to be performed in order to identify non-conforming or defective products produced by the process. The ...
What is Failure Modes and Effects Analysis?
Failure modes and effects analysis (FMEA) is a systematic approach of identifying and analyzing the points of failure and determining ...
What is Focus Group?
A focus group is a group of people belonging to different backgrounds to participate in a discussion regarding a specific ...
What is Rational Subgroup?
Rational subgroups allow to collect and arrange data into groups that are under similar conditions. In this case, variations are ...
What is Defects per Unit?
Sometimes, the dimensions or characteristics of the products produced by a process cannot be quantified to a continuous numerical value. ...
What is Reproducibility?
When a process is monitored, some characteristics need to be measured in order to compare them with the needed specifications. ...