Accuracy Notes: Definitions & Explanations PDF | Download eBooks
Study Accuracy lecture notes PDF with total quality management definitions and explanation to study What is Accuracy?. Study accuracy explanation with TQM terms to review total quality management course for online MBA programs.
Accuracy Definition:
Accuracy refers to the ability of the instrument to measure the true value correctly on average.
Introduction to Statistical Quality Control by Douglas C. Montgomery
Accuracy Notes:
DMAIC allows to measure the quality characteristic of the products in its second phase called measure. For this, a measurement system must be used. This measurement system should be capable enough to give accurate measurements. Accuracy is defined as the level to which the measured value is close to the correct or target value. It basically shows the closeness of a measured value to the target value. Based on the difference between the two values, percent error can be calculated which shows the error of measurement in percentage. For example, if the actual diameter of a rod is 5 cm and the diameter is measured to be 5 cm, the measurement is accurate. Any measured value other than 5 cm is not accurate.
Keep Learning with TQM Notes
What is Closed-loop Corrective Action?
When feedback from customers is collected regarding any product or service, it is analyzed and areas of improvement in product ...
What is Product Process Design Costs?
Quality control of products incur costs to the organization. These are called quality costs. Quality costs are divided into three ...
What is Partnering?
International market can be targeted by joining hands with firms in another country. This way of reaching out to new ...
What is Kano Quality Design Model?
Relationship between quality and design was developed by Professor Noriaki Kano. The model highlighting this relation, called Kano model, shows ...
What is Cuscore Control Chart?
Cuscore is the short form of cumulative score. Cuscore ?Q? can generally be calculated as the summation of et0 rt. ...
What are Non-Conforming Products?
Variations can occur in products and processes. There can be two types of variations in processes, assignable variations and non-assignable ...
